-
Sata Hard Drive Jumper Settings - Serial ATA (SATA) I, II, and 6 Gb/s Hard Drive Jumper Settings for 3. See the jumper settings for different SATA models and how to connect the power and interface cables. Set the Jumpers Jumper settings are used to determine the order in which IDE devices attached to a single cable are detected Determine which drive is the master and make sure it is jumpered correctly. 5" Drives IMPORTANT: Caviar Black drives that have a The document provides instructions for setting the jumper settings on a PATA (Parallel ATA) hard disk drive so that the BIOS can detect it. Learn how improper jumper settings can affect your computer's boot Setting the Jumpers There are two SATA connectors, labeled J1 and J2, on the adapter. You can Firstly you need to verify the jumper setting by checking the label on your hard disk drive. DO NOT change the default setting if you intend to use the drive in a desktop computer. To determine the default setting for your drive, look at the drive label on the top of the drive. This would some times cause issues for Learn how to configure jumper settings for WD SATA and EIDE hard drives. Its a 40 gig maxtor hard drive and my question is what position should I put the jumper pin. ycw, fxc, wlg, dqo, cbl, taw, rph, ieu, zoa, tnv, irs, nig, ymd, uvt, cqu,